Action Hardware

Chain Hoist Direct Drive 1in Shaft

SKU:
2000D
MSRP: $83.52
$69.59
(You save $13.93 )
Adding to cart… The item has been added
  • Shipping Cost? For the cost of shipping your item please add the item into the shopping cart. Once the part is in the cart fill out address information in the cart under the Shipping area in the Summary section. Our system will then calculate the shipping fee based on your location and the weight of the product. This is all done before you are asked to provide payment information.
Direct Drive for 1" shaft Includes 26' of hand chain, 1 chain keeper, 2 shaft collars and a 1/4" key Needs 5 3/8" minimum offset from center line of shaft to wall. Sprocket measures 8-13/16 inches in diameter CHAIN HOIST INSTALLATION: Shaft Mounted units (1:1, JR-ST, JR-RD, JRG):
  • Install Unit onto Door Shaft.
  • Sprocket mounted to Rolling Door on JR-RD or sprocket on JR-ST need to align with the small 9 tooth sprocket.
  • Secure from sliding along the shaft with set screws and shaft collars as applicable (use shaft keys where needed.)
  • Install Roller Chain on JR-ST or JR-RD (the roller chain has a connector link to split chain and reconnect.
  • Install bracket to wall on JR-ST- or JRG if desired to keep unit from swinging.
Wall Mounted Units (3:1 models, 4:1 models):
  • Install Sprocket onto door shaft with key and set screws.
  • Install the main unit to the wall so that the roller chain will be free of slack when installation is complete (shorten roller chain if needed).
  • If not already completed during the previous step, install the roller chain between the main unit and sprocket on the door shaft (move the sprocket on the door shaft if necessary to ensure the sprockets are aligned).
All Units:
  • Thread the hand chain around the pocket wheel and let it hang (extra chain may need to be purchased in doors in excess of 14ft or vertical lift or high lift doors).
  • Adjust the length of the chain so that the loop will hang around 1ft off the floor.
  • With the chain hanging freely, a link on the hand chain will need to be ben open and then closed again to complete the look. This can be accomplished with two sets of pliers
  • Install the chain keeper on the wall at a reasonable height and location so that the chain will be clear of the opening when engaged in the keeper.
DIMENSIONS:
  • OUTSIDE DIAMETER: 8-13/16 INCHES
  • INSIDE DIAMETER: 7-7/16 INCHES

CHAIN-HOIST-MANUAL.PDF