If you own a Genie Intellicode garage door opener and you need to replace that unit’s circuit board, North Shore Commercial Door Co. has a variety of circuit boards in stock at low prices. Your circuit board will have its model number displayed on the face of the board so you will not have to uninstall the circuit board to find your model number. Genie 31181R circuit boards have been given new model numbers by Genie Company. The new model number is 20393R but rest assured, the specifications for the circuit board remain unchanged. If your garage door opener needs the Genie 3118R Intellicode circuit board, you can safely replace that old board with the 20393R board. If you are still unsure as to the correct circuit board for your garage door opener, the staff at North Shore Commercial Door Co. recommends you contact Genie Company technical support for information about the best replacement circuit board. Once you receive that information, you should return to North Shore Commercial Door Co. to get the best prices on these replacement circuit boards. As you replace your garage door opener circuit board, North Shore Commercial Door Co. recommends using the Woods Garage Door Opener Surge Protector as a safety precaution. This surge protector features 900 joules of surge protection and protects that garage door openers from spikes, surges and sudden changes in electrical voltage.
•Compatible with all 1997 and newer Genie Intellicode Chain Drive garage door opener operators.
•Compatible with operator models: PMX60, 65, 70, 75, 80, 300-IC, 500-IC, IC-520 and more
•Model 20393R is the same as Genie part number 31181R
For more product & how-to videos subscribe to our YouTube channel:
QUESTION: I have a Genie Promax PMX-80 but don't know the year built. It came with the house. I'm guessing it was installed in the 90's. Some references refer to different circuit board numbers. Should the 203393R work with this PMX 80 model? by Ken J 5/10/2014
ANSWER: Remove the old circuit. Get the numbers off of the old board. Call tech support if necessary as I first purchased the wrong board the first time. by Ted M a
QUESTION: Hi, After I replaced the new circuit board. I still get the same problem that door can't close completely. Its closing down to the level of safety beam then automatic going up. I adjusted the close and open sensor switch. and also check level contact of safety beam. But it still happened the same. The motor run perfectly. Do you have any idea ? Thank you.<br /><br />Merry Christmas and Hapy New Year by Johnny V 12/24/2013
STAFF ANSWER: Call the manufacture tech support line 800-275-6187. by Matthew O a
QUESTION: is this board compatible with screw chain Genie garage door? by Johnny V 12/17/2013
ANSWER: Yes.but make sure that the board is the exact same number. Call tech support if you are not sure. Why are you replacing the circuit board? by Ted M a
REPLY: Thank you for your answer. I need to replace the circuit board because the close adjustment switch is not working. I called Genie tech support they gave me the model number 20386R. I already order one from you. once again, thank you very much. Its a helpful answer. by Johnny V r
REPLY: Good luck Johnny. Make sure power is off and keep steel tools away from the circuit board as I shorted out my test board from my second garage door! by Ted M r
QUESTION: Own a Genie 2042 belt drive....started acting erratically. Tried to reset limits, would not accept changes or reset. Called Genie tech support and walked through lots of button pushes/unplugging. Tech support said that main pc board was likely bad. Is 20393R 31181R the right one? by Neal M 5/4/2013
STAFF ANSWER: Verify with tech support the correct replacement board number. They are always changing the numbers and updating them, we want them to verify that for you, then find the part on our site. 800-275-6187 by Matthew O a