• Enter DESIRED FOOTAGE into the QUANTITY box below - Please note item will arrive as ONE PIECE in desired footage length
  • Usually Ships Following Business Day
Action Industries

Storm Shield 2 (SSP001-00-X)

SKU:
SSP001-00-X
  • Enter DESIRED FOOTAGE into the QUANTITY box below - Please note item will arrive as ONE PIECE in desired footage length
  • Usually Ships Following Business Day
atc-product:
NSCD-THSB
atc-product:
SSADH-10-X
atc-product:
STORMSHIELD
MSRP: $6.86
$6.24
(You save $0.62 )
Adding to cart… The item has been added
  • Shipping Cost? For the cost of shipping your item please add the item into the shopping cart. Once the part is in the cart fill out address information in the cart under the Shipping area in the Summary section. Our system will then calculate the shipping fee based on your location and the weight of the product. This is all done before you are asked to provide payment information.
Keeping leaves, dirt, pests, and the weather out of your garage used to be a hassle. North Shore Commercial Door has found a product that makes sealing your garage door a breeze! Storm Shield 2 Peel and Stick Threshold Seal is every homeowners best friend. This seal installs on the garage floor right where the door closes. When paired with any bottom weather stripping, the threshold seal creates a nearly impenetrable seal. Made out of EPDM, the threshold seal can withstand temperatures ranging from -40º Fahrenheit to 150º Fahrenheit and meets California Fire Marshal and CPAI-84 flame resistance requirements. Measuring 3 inches wide, a 1/2 inch hump sits flush against the bottom seal of the garage door. ORDERING STORM SHIELD: Storm Shield Peel and Stick Threshold Seal is sold by the foot. To ensure the proper length is received, please measure the width of your garage door and add that to the cart. To Install the seal please follow the instructions below:
  1. Lay Storm Shield® from vertical track to vertical track. If necessary, cut per dimensions from outside of vertical track to outside of vertical track.
  2. Mark Storm Shield® to be notched by aligning end with outside of vertical track and marking in line with inside of track.
  3. Align Storm Shield® with jamb against vertical track. Mark backside of vertical track as shown.
  4. Cut X portion to notch Storm Shield®, repeat for the other side.
  5. Use a lint free cloth to clean floor with Acetone, as it will aid in removing moisture from the surface of the concrete. If Acetone is not available, Pine-Sol® can be used. NOTE: If using Pine-Sol® floor must be completely dry before applying Storm Shield®
  6. Snap a chalk line from jamb to jamb at the location that the door meets the opening when closed.
  7. Install Storm Shield® along chalk line removing liner and patting the seal down 6-8 inches at a time. ONCE STORM SHIELD® COMES IN CONTACT WITH THE CONCRETE IT CANNOT BE RE-POSITIONED.
  8. Garage Door Should be lowered on Storm Shield® and allow 24 hours for adhesive to take a set. Use a small roller to aid the adhesive in making contact with the floor if possible.
PRODUCT HIGHLIGHTS:
  • PART NUMBER: SSP
  • Sold by the foot
  • Measures 3 inches wide with a 1/2 inch hump
  • Peel and Stick backing for easy installation
  • Can withstand temperatures ranging from -40º Fahrenheit to 150º Fahrenheit

STORM-SHIELD-2-INSTALL.pdf