• Usually Ships 4 to 7 Business Days

PowerMaster Model GT Heavy Duty Drawbar Operator for Standard Lift Sectional Doors

MSRP: $2,174.59 - $3,732.15
$1,976.90 - $3,392.86
  • Usually Ships 4 to 7 Business Days
Adding to cart… The item has been added
  • Shipping Cost? For the cost of shipping your item please add the item into the shopping cart. Once the part is in the cart fill out address information in the cart under the Shipping area in the Summary section. Our system will then calculate the shipping fee based on your location and the weight of the product. This is all done before you are asked to provide payment information.
PowerMaster Model GT Drawbar Operator is used on Standard Lift Sectional Doors. The PowerMaster Model GT's motor is high starting torque, continuous duty industrial type, and is protected from overload by a current sensing or thermal type overload device. Primary reduction is by industrial rated gear box running in an oil bath. The motor controller is a heavy duty, across the line, full voltage, magnetic reversing contractor that is electrically and mechanically intertwined. The electrical components installed in a NEMA 1 enclosure integral to the operator. Individual terminal strips are provided for the connection of power supply line and all control devices. A transformer is supplied to reduce control voltage to 24 VAC. The operator is wired for an open/close/stop control station. A control circuit provides immediate reverse motor wiring on single phase operators. The positive chain driven, rotary type limit switches are supplied to limit full open and close travel of door. Limit switch adjustment is not affected by the removal of the motor or by manually operating the door. An adjustable torque limiting clutch is given to prevent the overloading of the operator. A disconnect arm for the manual operation of the door is supplied in case of power failure and a spring set solenoid released brake is provided. The final reduction and drive is a heavy duty roller chain and sprockets. The drive shaft is supported by oilite bearings and is a minimum of 3/4” in diameter. Features
  • Worm Gear Reduced Drawbar Operator
  • Auto-Detect Monitored Photo Beam for Simplified Installation
  • Solid State Circuitry with Feedback LEDs
  • Field Adjustable Built-in Functions
  • On Board Open/Close/Stop Buttons for Service and Adjustments
  • High Starting Torque Motor with Full Overload Protection
  • Quick Release Door Arm for Manual Operation
  • Available in 1/2, 3/4, and 1 hp
  • 115/230V 1ph or 230/460V 3ph